AVS Forum banner
1 - 1 of 1 Posts

· Registered
34 Posts
Discussion Starter · #1 ·
I have finally hooked up my new Denon 2806 with my Panasonic AE900 projector. I purchased a 15ft HDMI cable from Monoprice to run from my equipment room to my theater. The problem is - I'm not getting any signal over the HDMI. I can hook up component or S-video and it works fine - but on the HDMI input, I get nothing but a blue screen.

Anyone out there have a similar problem? Anyone have any suggestions on what I can do to correct this? Thanks!!

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.