AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
127 Posts
Discussion Starter · #1 ·
I thought I had this fixed but I don't. When I start my projector it turns on and I can see LED's and hear it running but no picture. Then when I send it a signal it shuts off and gives me a 2 digit code in the back display "PF" (the F is upside down and backwards.) If I cut the power a few times eventually it will project. Or if I turn it on about a half hours in advance it will work just fine, but I don't want to deal with that. When someone drops by and wants to see my HT it is extremely embarrassing. Please help, it's got to be some type of setting which I can't figure out. TIA
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top