AVS Forum banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
I have a Toshiba 43h70 I would like to get professionally calibrated. I am looking for a "recommended and experienced" ISF tech in the area of Baltimore, MD or one who is willing to make a trip here for a calibration.


Thanks for any advice/recommendations! Michael TLV??



[This message has been edited by superD (edited 05-24-2001).]


[This message has been edited by superD (edited 05-24-2001).]
 

·
Registered
Joined
·
277 Posts
Do a search on Chuck Williams and ISF. I believe he lives in the DC area and he comes highly recommended. Also check on the Keohi website (search for that also) as I believe he is from this area and his site is full of good info. Hope that helps!!


------------------

To Infinity and Beyond!!!
 

·
Registered
Joined
·
447 Posts

·
Registered
Joined
·
277 Posts
I knew Errol was probably lurking around here somewhere.


------------------

To Infinity and Beyond!!!
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #5 ·
Thanks Guys! Sounds like Chuck Williams is the man... I was hoping to find someone to do all the extras, like the duvatyne lining, etc and this forum certainly has given him high marks. I'll be emailing him soon.


The set is about to hit the 100hour burn in mark and another thread made it sound as though anytime after 100hour is good calibartin' time. I'll let everyone know how it went! Thanks again.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top