Hi, I am new to this board. I just found it two days ago so forgive me if this has been covered, but I did a search first and could not find an answer.
I just ordered a Panny(picked up the lingo quick) 42" WD5UY and will mount it on the wall dividing the living room and garage. I would like to run the cables thru the wall into the garage over to where the sat/dvd/and vhs is located in the living room and then back thru the wall. I will be using component and s-video cables.
So the question is, do I just put a hole in the wall and pass the cables thru? Or use electrical boxes at each location and I guess some kind of box cover with the appropriate connections? Also what kind of cable should I use?
Thank you for your help and I only hope that after time I will be able to help the next newbie here.
St. Louis Bob
I just ordered a Panny(picked up the lingo quick) 42" WD5UY and will mount it on the wall dividing the living room and garage. I would like to run the cables thru the wall into the garage over to where the sat/dvd/and vhs is located in the living room and then back thru the wall. I will be using component and s-video cables.
So the question is, do I just put a hole in the wall and pass the cables thru? Or use electrical boxes at each location and I guess some kind of box cover with the appropriate connections? Also what kind of cable should I use?
Thank you for your help and I only hope that after time I will be able to help the next newbie here.
St. Louis Bob