AVS Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
389 Posts
Discussion Starter · #1 ·
The info on my setup:


Receiver is Onkyo TX SR608


SETUP 7.1 System 14'x8' Room


FRONTS L/R

RB-61 II Bookshelf Speakers (pair)
http://www.klipsch.com/rb-61-ii-bookshelf-speakers-pair


FREQUENCY RESPONSE: 45Hz-24KHz ± 3dB

HIGH FREQUENCY CROSSOVER: 1500Hz

HIGH FREQUENCY DRIVER: 1" (2.54cm) Titanium diaphragm compression driver mated to 90° x 60° square Tractrix® Horn

LOW FREQUENCY DRIVER: 6.5" (16.5cm)

NOMINAL IMPEDANCE: 8 ohms compatible

POWER HANDLING: 100W RMS / 400W Peak

SENSITIVITY: 95dB @ 2.83V / 1m


CENTER

RC-42 II Center Speaker
http://www.klipsch.com/rc-42-ii-center-speaker


FREQUENCY RESPONSE: 88Hz-24KHz ± 3dB

LOW FREQUENCY DRIVER: Dual 4" (10.2cm) Cerametallic cone woofers

NOMINAL IMPEDANCE: 8 Ohms compatible

POWER HANDLING: 75W RMS / 300W Peak

SENSITIVITY: 95dB @ 2.83V / 1m


SUB

Omni S8 Subwoofer
http://www.miragespeakers.com/na-en/...i-s8-overview/

System Type Powered Front firing Subwoofer with Down firing port

Frequency Response 27Hz-120Hz

Amplifier Power Output 100 Watts RMS, 400 Watts Dynamic Power

Woofer 8" woofer with ribbed elliptical surround

Variable Low Pass Filter Yes

Inputs Low Level, Stereo High Level (Speaker Level)

Overall Dimensions cm: 37H x 30W x 39D

Weight 29 lbs. lb / 13.4 kg

Finishes Black

UPC 629303-13645-4

Part Number 13645


SURROUNDS

Cerwin-Vega! VM-5E
http://www.cerwinvega.com/home-audio...ers/ve-5m.html


1.After Audyssey do i set all speakers to 80HZ ?


2. Do I crank Intelvol to +12 (reason reciever sounds week not enough volume)


3. Do I turn on Dynamic EQ also Re EQ ?
 

·
Registered
Joined
·
12,418 Posts

Quote:
Originally Posted by EaglePC /forum/post/20798912


1.After Audyssey do i set all speakers to 80HZ ?

That's a pretty good choice. Try it.

Quote:
2. Do I crank Intelvol to +12 (reason reciever sounds week not enough volume)

I thought that was used to normalize across inputs: >>With IntelliVolume, you can set the input level for each

input selector individually. This is useful if one of your

source components is louder or quieter than the others.
 

·
Registered
Joined
·
389 Posts
Discussion Starter · #3 ·
thanks roger reletive -20 -10 is a bang just thought it was kind high volume then normal and +10 rocks


80hz good level intelvol helps +9


Dynamic EQ sounds louder but funky and it is on light
 
1 - 3 of 3 Posts
Top