AVS Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Banned
Joined
·
668 Posts
Discussion Starter · #1 ·
I did a search, but it seems that no one has come across this problem before.


I received the KD-CTC transcoder today. I have the progressive output from my Toshiba 3750 plugged into it. Then I use a VGA Switchbox cable (male DB15 both ends) to connect the CTC to the AE100's PC-in.


The problem is that the projected image looks totally washed out. It doesn't matter what I set the brightness or contrast to.


I know this isn't right. I have used a friend's KD-CTC, and it worked fine. The dip switch settings that I have tried on the CTC are:


The manual saids that dip switches should be set as follows: 1=off, 2=on, 3=off. I have tried all 4 combinations with switches 4 and 5.


I have also tried 1=2=3=off, but then I don't get a picture at all.


If you have the KD-CTC with the AE100, what dip switch settings are you using? What about the VGA cable - is it a straight through or crossed?


Thanks in advance.
 

·
Registered
Joined
·
2,378 Posts
Somebody did have problems with the CTC+AE100. Search the archives again. I think he contacted KD tech support.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top