AVS Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
I am in the middle of trying to remove my M&K driver from my MX125MK2 Dual 12" Sub as I believe the coil is bad cause it is popping and want to send it to be repaired. I have removed the screws and am trying to remove the driver without success. Is it glued into the cabinet? How do I remove it?


Thanks

Chris
 

·
Registered
Joined
·
168 Posts
I had to remove the driver to have the surround replaced once in my old V2B and yes, after removing all the screws ,you'll have to carefully pull the speaker away from the cabinet. They use a very tacky sealent and I think there's a thin gasket on it. I used the thinnest mini flat head screwdriver in my Radio shack set. Came right out. Another way that might work is supporting the sub with the driver facing down and allowing gravity to drop it out.(may take awhile or this may not even work, maybe someone else can chime in.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top