AVS Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
211 Posts
Discussion Starter · #1 ·
Hey there,


I was wondering if somebody could help me what the next thing is that I need to do to successfully reduce overscan on my PC --> DVI-HDMI --> 1080p TV (JVC 61FH97). I can get the resolution down to 1884x1062, but if I try to adjust it lower than that, the screen will no longer accept the resolution. I don't know what to do with the "SYNC WIDTH" parameters; I'm wondering if these might help, and if so, what it means to adjust them.


Any help would be greatly appreciated.


Thanks!

Richard

INITIAL TIMINGS

PowerStrip timing parameters:

1920x1080=1920,88,44,148,1080,4,5,36,148500,1


Generic timing details for 1920x1080:

HFP=88 HSW=44 HBP=148 kHz=67 VFP=4 VSW=5 VBP=36 Hz=60


VESA detailed timing details:

PClk=148500.00 H.Active=1920 H.Blank=280 H.Offset=72 HSW=44 V.Active=1080 V.Blank=45 V.Offset=4 VSW=5


Linux modeline parameters:

"1920x1080" 148.500 1920 2008 2052 2200 1080 1084 1089 1125 +hsync +vsync

REDUCED TIMINGS

PowerStrip timing parameters:

1884x1062=1884,106,44,166,1062,13,5,45,148500,1


Generic timing details for 1884x1062:

HFP=106 HSW=44 HBP=166 kHz=67 VFP=13 VSW=5 VBP=45 Hz=60


VESA detailed timing details:

PClk=148500.00 H.Active=1884 H.Blank=316 H.Offset=90 HSW=44 V.Active=1062 V.Blank=63 V.Offset=13 VSW=5


Linux modeline parameters:

"1884x1062" 148.500 1884 1990 2034 2200 1062 1075 1080 1125 +hsync +vsync
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top