AVS Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
326 Posts
Discussion Starter · #1 ·
Hi All,

Just in the process of setting up my Barco 708data, and feel that the picture is not as sharp as it could be, is there any way to adjust the sharpness, would these leavers in that are at the bottom of the tubes ,see picture have any affect. If not what are they for.

Thanks in advance


Steve




Hope by posting this picture that i am not in the wrong.
 

·
Registered
Joined
·
326 Posts
Discussion Starter · #2 ·
Perhaps should have given a little more detail,


I have adjusted the focus, to the best I can get it, I am feeding a component signal, which is not line double. read on the Barco forum about adjusting the magnets, what this about ? any info would be nice,



Come on you guys 49 people have read this post and with no replies, please some one must have some input. :(



steve
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top