AVS Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
2,194 Posts
Discussion Starter · #1 ·
Hi everyone,

I have a Channel Master 4228 antenna with a CM 7777 Titan2 preamp running to one HDTV set.


We're adding another HDTV set in the next week or so and I was wondering what I need to split the signal and run it to the new set we're adding.


I don't know if I need another CM product, a distribution amp, etc. Any suggestions would be welcome
 

·
Registered
Joined
·
947 Posts
one 2 way splitter rated to at least 1000mhz installed off the "to tv port" of the preamp powersupply with a short piece of coax. dont spend more than 5 bucks either! nothing fancy or gold colored.


distribution amp not required.
 

·
Registered
Joined
·
2,194 Posts
Discussion Starter · #4 ·
Rick, thanks -- my problem, though, is that the TV is on the other end of the house that we're adding.


The main line from the antenna runs near it...is it possible to split the signal there, add another power supply, or put the original power supply there instead of near the other, older HD set?
 

·
Registered
Joined
·
2,134 Posts

Quote:
Originally Posted by DM2006RI /forum/post/0



The main line from the antenna runs near it...is it possible to split the signal there or put the power supply there instead of near the other, older HD set?

Exactly what you should do. Rick was simply saying put the split AFTER the power supply. If it makes sense to move the power supply, have at it!
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top