AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
299 Posts
Discussion Starter · #1 ·
I thought I read that someone had used HomeSeer to monitor x-10 traffic and then execute a specific Girder command via batch file. I have three scenarios I'm trying to accomplish with automating my home theater:


1) Monitor x-10 traffic via CM11-A and trigger a Girder event when appropriate. Example - Wait for A1 on and then pass a command to Girder to "Start Theater"


2) Monitor phone line and pause movie when phone rings. Example - Phone rings, lights are brought back up, dvd is paused and on-screen message is displayed


3) Voice Command - I know HomeSeer can run a macro based upon voice commands. Can HomeSeer communicate with Girder?


Also, I'm sort of new to Girder. Would anyone mind posting a "real world" example of your .GML file for me to learn from? My "theater on" event is sort of complected and an example of someone else's work would be quite beneficial.


Thanks to all!!!


Jeff
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top