AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
543 Posts
Discussion Starter · #1 ·
I have horizontal sync problems when I use the RCA VHDC-300 RGB to component transcoder with my NEC LT100 projector. The picture will be fine for a while, then it will begin to tear.


I don't have this problem when I send the RGB signal to my projector, but my projector looks better (better color & fewer motion artifacts) with component than RGB so I was hoping to switch over to using component.


Strangely, I have only seen this problem when I send the output of the transcoder through a VGA switch so I can swtich between that and the output of my iScan.


Has anyone else had this problem? Would a different transcoder help?


Here is a picture of what the tearing looks like

http://people.mn.mediaone.net/joe-linn/DSC00040.JPG


Thanks


Joe
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top