Get an exclusive sneak peek into our new project. >>> Click Here
Our native mobile app has a new name: Fora Communities. Learn more.

How do i reset a 1252 to factory settings?

307 Views 8 Replies 3 Participants Last post by matrix, Sep 12, 2003

hans14914

Discussion Starter · Sep 10, 2003

I am having problems converging my 1252 beacuse the screen geometry is so bizzare, how do i reset everything back to the way it was shipped from the factory to get a new start. I am using a 120" screen, and that was the factory default, so it should be fairly simple if i can get it back.

Thanks

Hans

Save

Status: Not open for further replies.

1 - 9 of 9 Posts

hans14914

Discussion Starter · #2 · Sep 10, 2003

top

Save

hans14914

Discussion Starter · #3 · Sep 11, 2003

Can you please explain both operations? I am relatively new to the sony chassis, this being my second. Most of my experience was with barcos and electrohomes. I am not a newbie, been working with pjs for over 4 years, but it would make this install so much easier to start from scratch.

Thanks

Hans

Save

suyver

· #4 · Sep 11, 2003

To completely reset the settings to the factory default, do the following:

1) Press 'test' for a few seconds. You should get a message asking if you'd like to enter the serviceman control mode. Press arrow-up (yes) to do so.

2) Press arrow-left and arrow-right at the same time. You will be asked if you'd like to return to the previously saved mode. Press arrow-up (yes) to do so.

3) Repeat 2. Now you will be asked if you'd like to return to the factory presets. Press arrow-up (yes) to do so.

4) Keep 'memory' pressed for a few seconds. The data can then be stored in all memories and you can start from scratch.

Good luck!

-Freek.

See less See more

Save