AVS Forum banner
Status
Not open for further replies.
1 - 6 of 6 Posts

· Registered
Joined
·
152 Posts
Discussion Starter · #1 ·
I can't find this in the manuals anywhere. Perhaps I'm blind.


My pj is set to floor as I want it to be, but the image is backwards.

How do I switch it back so text reads left to right?


thanks!


Eric
 

· Registered
Joined
·
16,947 Posts
Eric ,


-- there are sets of plugs on the DA and DB boards that switch the image around . It is in the manual actually [ see page 12 ] . Be sure that they are all inserted in the same direction [ white lead ] , sounds like you have a few that may still be flipped since the image is right side up but backwards .

--- Best of luck ,

--- Jason Berg
 

· Registered
Joined
·
18,489 Posts
you want the three 2 pin connectors on the left hand PC board under the top cover. The ones on the right board (convergence board) flip the image upside down.


Curt
 

· Registered
Joined
·
2,112 Posts

· Registered
Joined
·
152 Posts
Discussion Starter · #5 ·
Thanks guys!


I rtfm'ed three times and never figured that out. I'll try to get on it tonight. It's work day at church and I have to go be handy.


I'll try to be less needy in the future. Given some of the discussion here about others frying their tubes, I figure if I'm in doubt, I'll ask first.


Y'all are awsome!


Eric
 

· Registered
Joined
·
152 Posts
Discussion Starter · #6 ·
cool! that was simple, too.


this is fun. now I get to set up a screen to test it on and start working on converging the tubes.


stumbled across the macrovision flutter coming from my dvd player. That's pretty annoying, isn't it?


-ejs
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top