AVS Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
153 Posts
Discussion Starter · #1 ·
I powered up my 1030Q1 and fed it a signal, but i dont know how wide the projection is set up for. Is there any way to tell whether it has been set up for 100"diag or 72"diag? I have just opened up the PJ using the instructions from the eboyztoyz site. I want to use 80" witdth projection (100" diagonal) which the projector does support.

Thanks for info....
 

·
Registered
Joined
·
16,656 Posts
Nandu ,

-- a good indicator is the lens setting but after that it is a guessing game .

-- you can set the proper throw distance for the setting it is at and see how close it is to what it should be [ this should give you an idea of what the previous owner was doing - but nothing is certain ] .

-- Best thing to do is just start fresh and go through the process [ the end result will be much better ] .

--- Best of Luck ,

--- Jason Berg
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top