AVS Forum banner

Status
Not open for further replies.
1 - 8 of 8 Posts

·
Registered
Joined
·
71 Posts
Discussion Starter · #1 ·
Dear guys:


Since my Barco 701 has only RGBS input.

people told me that i can use powerstrip and Y connector for HV to S signals. Is that true?

How to configure the powerstip?


thanks guys
 

·
Registered
Joined
·
72 Posts
I normally use a "t" piece connector to combine the H&V.

Alternativly some Graphics cards allow you to use combined (composite) sync.


You should find that the 701 has auto detection for +ve or -ve sync.


Start with 800x600 resoloution.
 

·
Registered
Joined
·
68 Posts
I got the same projector combine the suncs with a T piece and switch the syncs to negative in power strip you may have to play with the advanced timing options to ge the image to look nice i find mine looks best at [email protected]
 

·
Registered
Joined
·
1,191 Posts
Hello Rob ---


what is "a magic interface from Barco" ?


thanks
 

·
Registered
Joined
·
1,191 Posts
Does the MAGIK interface work for all brands of PJs, or just Barcos?
 

·
Registered
Joined
·
449 Posts
it is a transcoder,trans RGBHV signal to RGBS signal,so your barco can accept PC RGBHV.

i have the circuit for this transcoder,if you like to DIY,let me know your EMAIL,i will send you the circuit! it is not cost than $10!


thanks!
 

·
Registered
Joined
·
1,191 Posts
Thanks for the offer, Moome...


my email is [email protected]



The barco website shows this device as being able to display on two monitors--- one input, two high bandwidth outputs.


Anyone use one?
 
1 - 8 of 8 Posts
Status
Not open for further replies.
Top