AVS Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
3,137 Posts
Discussion Starter · #1 ·
Hey all.


I've just ordered a new green tube for my 1292, since the one in the

PJ, has the very nice long stripe down the middle:)


What should I check before installing the new tube? It should be noted

that I've had the set running for many, many hours, switching it on and

off many, many times, without anything happening to the red and blue.


Thanks!


Nicholas
 

·
Registered
Joined
·
18,506 Posts
I'd run the old tube for 100 hours before replacing it.


Chances are someone disconnected the yoke wiring while the set was on, but I'd open the set while it's running and tap on all of the PC boards to see if you have a bad solder joint. I'd also take off the CRT sockets off the R and B tubes to make sure those tubes are not lit up while you do this.


Curt
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top