AVS Forum banner
1 - 3 of 3 Posts

· Registered
9,873 Posts
Welcome GIL200, don't know if this helps but set the unit in "standby" mode, disconnect power cord and plug it back in after about a minute.

Now to initial factory settings (pg. 90), go to "ADVANCED SETUP" procedure section, set "User Preset" function for "RESET". Next time system power is turned on it will automatically reset to factory settings.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.