AVS Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
426 Posts
Discussion Starter · #1 ·
I have a DC-2 and will be using it for just Home theater. I want to run it with DD and DTS with Logic 7. Any pointers on special setting or any ideas on how you think it should be set. Thanks
 

·
Registered
Joined
·
1,598 Posts
Obviously you should use 7 speakers (plus sub(s)).

I suggest dipoles at the side and direct radiators in the rear.

Calibrate it using the internal test signals and you're good to go!
 

·
Registered
Joined
·
426 Posts
Discussion Starter · #3 ·
Thanks for the reply. On the calibration, should that be done to 85db or 75 db? I'm using Parasound amp and turned them up to the THX mark. I have a signel meter, what is the be ways to calibrate them and what should the rears and sides be calibrated to.


Thanks
 

·
Registered
Joined
·
5,549 Posts
75db 'C' weighted for all speakers. If you don't have the manual you can download it from Lexicon's website. Be sure to get the 'Theory and Design' book too as it will give a lot of details on setup.


Shawn
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top