AVS Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
63 Posts
Discussion Starter · #1 ·
Ok,


I got my HS10 from Japan today :)


I'm using an HTPC and feeding the HS10 a 720p signal (I'm using sideshot, so there's no sense in using 1:1 mapping--poor room arrangement).


Anyhow, with this 1280x720 resolution, the HS10 is overscanning a bit, it's chopping about 40-45 pixels off of each side...


What are some powerstrip changes I can make to get rid of the overscan? The overscan occurs in both full and full-through modes.


Thanks.


PS. Searching the "official" HS10 threads sucks, hard to find info one wants. Too many pages to read through, and I've been following them since they were formed. (Er, that is, the official threads in the
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top