AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
47 Posts
Discussion Starter · #1 ·
I've seen an odd behavior with my new HT200DM projector (running software version 1.16DM), and I'd just like to see if anyone else has seen this behavior, too.


If I start up the projector with my receiver turned off, so the projector isn't getting a signal... and I let the projector warm up and display an image, then usually it'll display static vertical bands of garbage on my screen. There's nothing I can do to get rid of this garbage other than to put the projector into standby mode again; none of the on-screen menus will work, and turning on the receiver so that the projector is now getting a signal *still* won't get rid of the garbage.


If the projector is receiving a signal while it starts up, then it displays that signal fine; the problem is only when it doesn't have a signal until after it starts up, and then it locks into this vertical-bar garbage pattern. To get it out of this, I have to put it into standby mode and let it sit for a few minutes; if I start it back up again soon, it sometimes is still stuck on garbage even when I've already turned on the receiver.


This isn't really a problem, it's only a nuisance when I forget to turn on the receiver first. Has anyone else seen anything like this from the 200DM?

 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top