AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
I have a relatively new Hughes E86 HD Receiver hooked up with a diplexer. In other posts I have seen people posting signal strengths from local OTA channels. When I try to do this on my box I get a reading of Zero on all OTA channels. The channels come in OK (Although channel 5-NBC has alot of pixelization- it gets very bad at times), but, they still show up as zero on the stregth meter. Is this a function of the diplexer? Should I remove the diplexer? Should I use the meter, if I figure out how to use it, to point my OTA antenna? Sorry for all the questions, but, I want to optimize my set up.


PS. CBS may soon by OTA, so I won't need the diplexer in the near future.


Thanks for your help.

SW
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top