AVS Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
43 Posts
Discussion Starter · #1 ·
I have a Hughes HTL-HD. When the receiver truly doesn't get a signal for a channel, it will instantaneously show NO SIGNAL. When it gets some signal (perhaps it's weak or multipathing issues) it takes the receiver about 2 seconds for it to display NO SIGNAL.


Therefore, perhaps the reason why I can't get WNBC-DT (beyond the low power) is multipathing? or is the receiver just not getting a strong enough signal to lock-in.


Anybody know?
 

·
Registered
Joined
·
491 Posts
I "view" mulitpathing as pixelation on my screen, not a lack of signal. What is the signal strength meter reading when you experience this?
 

·
Registered
Joined
·
43 Posts
Discussion Starter · #3 ·
Since I have firmware 1.06, I don't have a signal strength meter in the HTL-HD ---- so I can't tell. I guess i'm trying to understand what it means when the receiver takes a few seconds to give a NO SIGNAL - is it just a lack of strong enough signal for the tuner to lock-in?
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top