AVS Forum banner
1 - 1 of 1 Posts

127 Posts
Discussion Starter · #1 ·
So I picked up monoprices version of a powerbridge. I can easily seal up the electrical side as it uses a 1 gang box, and I could put a putty pad.

The issue is with the hdmi side of the bridge where the wire comes in. I don't think code would allow me to use a 2 gang box with the low voltage and electrical in the same box.

It appears that caulking the low voltage side won't work cause its a big hole for the hdmi cable to come through.

Great stuff expanding foam maybe?

Any ideas are really appreciated
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.