AVS Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
166 Posts
Discussion Starter #1
I have the Mits HD500 receiver, I'm starting to lose my OTA channels. Last night I lost NBC so I went to do scan and then I lost ABC as well. When I put the channel # in manually I get a signal of 80 on ABC. I dont know why I cant lock it now. I tried to unplug my receiver for about 10 min and rescaned again with no luck. Is there another way to reset this receiver or does anyone else have any ideas.


Thanks in advanced.


John
 

·
Registered
Joined
·
301 Posts
John,

I think they're still doing some kind of work on the transmitting end in NYC, most of my channels have been acting screwy too. (I have a DTC-100)

-Dave


[This message has been edited by dcarl (edited 08-14-2001).]
 

·
Registered
Joined
·
166 Posts
Discussion Starter #3
Dave, good answer...I hope that's it.


John
 

·
Registered
Joined
·
1,502 Posts
Other people and I have been having a similar problem with the Toshiba STB since last week (see these posts: post 1 post 2 )


The first post will show you how to get around this problem to at least be able to watch NBC and ABC (it's ugly but it works).


Someone had contacted engineering at both of these stations, but so far has not received a reply (or hasn't reported receiving a reply)


[This message has been edited by Bill Broderick (edited 08-14-2001).]
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top