AVS Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter · #1 ·
Hey guys,


My PJ went down a little while ago, and I haven't had time to look into yet.

Before I do anything stupid I wanted to check here.


I have had a 4805 since last Christmas thanks to this Forum.

It has run smoothly with no problems at all. It has roughly 200+ hours on it.


Now, when I turn it on - it turns on and sounds like it typically does, but no image appears. There is nothing coming from the lamp/light source/etc.

I've consulted the minimal instruction booklet, but it hasn't helped at all.

The "power light" still lights up green (it says it would light up red if there were a problem).


Any ideas?


Thanks in advance!

RC4
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top