AVS Forum banner

Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
339 Posts
Discussion Starter · #1 ·
I heve a progressisve scan outpu on my dvd player but my Barco 808 graphics did not accept it because there is some kind of green /red image.

The signal seems not to be accepted.

Must I absolutely buy a video converter that costs or is there a manipulation to make YUV accpeted by the barco?

Perhaps in upgrading the soft I do not know?


help Me

Regards

Bruno
 

·
Registered
Joined
·
465 Posts
Hello Bruno


The G808 don't accept component only RGB so you have to buy a converter to watch component

Only the 808s 1208s and 1209s have a component input


Rob
 

·
Registered
Joined
·
339 Posts
Discussion Starter · #3 ·
thanks for you answer. But is it the input board which is different between the 808s and the the 808g. Can we found a used one perhaps?

An upgrade of the sofware is possible to enable it ??

Regards

Bruno
 

·
Registered
Joined
·
46 Posts
Hi,


nope, no chance as I know. The Inputboards are not interchangable bewteen 808s ( which is YUV capable) and the 808. Also a software updated will not help. The only way is a signal converter. Because you are located in France I suggest the Burosch CON-1. Its about 200Euro. With this device I ran my old Denon2800 progressive with my Barco808. Works fine. Another one converter comes from KeyDigital.


Best regards


HArry
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top