AVS Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
49 Posts
Discussion Starter · #1 ·
 http://www.aartech.ca/docs/A0314.pdf

There is the instruction manual that comes with it.

This may be a tough one. I doubt if many of you have experience with RJ-45 and 4 Pair 110 wiring, I sure didn't know what it was. The instruction manual is a joke. I guess they assume you know about 4 Pair 110 wiring. The instructions dont even call it 4 Pair 110 wiring, they just call it "110 connector" It took me a while to even find what that connector is realy called by looking on google.

That part that gets me confused is that you are supposed to use a CAT-5 wire to connect the Wall Dock and use 4 Pair 110 wiring to the Output Wall Plate. The instructions show them using a RJ-45 connector on the Output Wall Plate, and they just show the 8 wires going to the 4 Pair 110 wiring connector. All eight wires are color coded, but the instructions dont say anything about which color goes where, or even how to secure the wires to the block. I searched and found this http://www.deepsurplus.com/Network-S...10-Wiring-Plug , so I assume I can buy this, attach the wires to it, but even then I have no idea what wire goes where on that plug. I have tryed contacting Channel Visions customer support, but I haven't gotten a response, and doubt that I will. I figured someone on here might know how to make this piece of crap work..If not, I will have to try to get some type of refund from the merchant. Thanks!
 

·
Registered
Joined
·
590 Posts
I can't even get the stinkin' PDF to download all the way
 
1 - 2 of 2 Posts
Top