AVS Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I have a RTV 5080 and am trying to use the IR Blaster to interface with a Digital Cable Box - Motorola DCT2000.


The standard setup assigns an IR Blaster code of 4476.


The setup did turn on the Motorola DCT2000 cable box.


However, when I'm in the Channel Guide of RTV or just trying to change channels up or down, it triple sends each of the three digits through the IR Blaster towards the cable box (i.e. channel 301 send 333 (pause) 000 (pause) and then 111. The cable box apparently rejects the command and stays on the current channel.


Any ideas?


Thanks in advance.



Don
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top