AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
112 Posts
Discussion Starter · #1 ·
Hi

I have used the xantec products to wire IR in my apartment.

hard wired receivers, emitters and a distribution block.

remotes are sony commander 3000's

I have posted a diagram at....
http://www.visi.com/~mgason/IR.htm


I have a problem with interference.

when receiver A is connected it works fine. accepting signals from the lower lounge area. A remote used in the upper mezzanine area will not work with receiver A.


when the receiver B is connected a remote on the mezzanine works and using one from the lower lounge area will not work receiver B.


Connect both receivers to the distribution block and neither works properly.

given that...

1. neither one works when a remote is pointed at it from the wrong area (range is too great)

2. the direction in which the remote is pointed is opposite for each receiver.


why cant I get them to both work at once!!!

thanks in advance for any help.

mark
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top