AVS Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
Anyone know what the correct IR code is for a Philips DSX5353 Directv box? I have tried all the standard ones in my Replay 4040 with no success.
 

·
Registered
Joined
·
2 Posts
I have the DSX 5350 and also cannot find a code that works. Have you been able to solve the problem?


I am upgrading from a 2000 series that was working fine with the 5350.
 

·
Registered
Joined
·
3,139 Posts
What was the code you were using with your RTV2000?
 

·
Registered
Joined
·
2 Posts
I was using code 1076 on the 2000 series to control the SAT. It worked OK. When I tried using the same code on the 4000 series - no joy. I also tried all the other codes, and none worked. I even tried using the fine tuning settings (increased the times) - no good.


Any help or ideas would be greatly appreciated or it's off to Circuit City for a new box.


Thanks
 

·
Registered
Joined
·
3,139 Posts
If you have been following jtl's recent thread about IR codes in the R4Ks, it does appear that they are using a different source for the IR codes than the one they used in the earlier models (that being UEIC).


Just FYI, the SAT/1076 code appears to use an RC-6 signal with device code 39.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top