AVS Forum banner
1 - 1 of 1 Posts

942 Posts
Discussion Starter · #1 ·
I have a bit of a newb question. I would like to create my own IR flashers as buying them in the US and importing them into Canada is costly.

Since we have Radio Shack here, does anyone have any idea on what I would need to create a basic flasher?

I would assume the following:

1/4" phono male jack

lots of wire

Infrared emitter

Is there anything else I need like capacitors? I figure to tie this into an RTI system that has 1/4" phono jack output. The idea would be attach wire to phono male jack and then the other end to Infrared emitter.

Any suggestions would be appreciated.


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.