AVS Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
72 Posts
Discussion Starter #1
Gentlemen,


I would like to get in on the ISCO deal. My G-20 is upside down lying on it's top in a soffit cushioned by styrofoam chunks. I have about a half inch of material separating the very top of the projector (above the lens) from the surface upon which it rests (if you see what I mean).


Do you think that I can get the ISCO down low enough so that the output of the projector enters the lens appropriately? Can anyone with a similar setup measure the center of the ISCO lens to the base of the stand in its lowest postition? Will I need to invert the ISCO base, attach it to the top of the soffit with the lens hanging down?


In terms of the horizontal dimension, what should be the distance between the G-20 lens and the ISCO?


Will I just have to buy one and fiddle around?


Thanks. Your help is much appreciated.


Denny L.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top