AVS Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
54 Posts
Discussion Starter #1
I just swapped out the Blue and Green tubes but the image on the blue tube is rapidly getting larger then smaller like a flicker
I have removed the yolk and reinstalled several times and it does not seem to make a difference. It did not do this before the swap I did have to change the high voltage leads but everything went smoothly . Any one have any Ideas? Thanks Rich
 

·
Registered
Joined
·
1,425 Posts
When the picture gets larger and smaller it is usually caused by a bad connection on the high voltage lead. Two ends to it, one at the HV splitter and the other at the CRT bell. Turn her off, wait a few minutes and check both ends. Remember that you are dealing with 30 or 40,000 volts.


Scott
 

·
Registered
Joined
·
54 Posts
Discussion Starter #3
Thanks Scott I was afraid that I may have to redo the bell end maybe too much silicone I will try the splitter end just to remain optimistic
. I did learn that it is easier to attach the hv cable after the tube is in the projector. Thanks again Rich
 
1 - 3 of 3 Posts
Top