AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
6,126 Posts
Discussion Starter · #1 ·
I had the opportunity to use a neat tool for moving and lifting anything up to 700 lbs. The Escalera motorized hand truck with

LPA-1 lift plate attachment. The lift plate attachment was very stable with a 500 lb. cast iron boiler block raised all the way up.

However it will only raise up to 54 inches. I see no reason that a 2 or 3 foot spacer between the lift plate and projector could be used. The best feature of this for my purposes is it's ability to climb stairs under it's own power. For someone who has alot of projectors to service this would be an awsome time and back saving tool. Hang a GP 5000 from the ceiling all by yourself and not crack a sweat... Go to www.escalera.com


Chip S. :cool:
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top