AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
41 Posts
Discussion Starter · #1 ·
I have a low ceiling so I needed to build a custom mount. This done, my projector's crt housing is fully below the drywall ceiling in the front and about half way in at the back. The board section is fully nested in the joists. I was wondering if anyone has such a system and how they manage to access the project whilst maintaining good appearances.


Also this mount brings the lenses to about 2" below the ceiling, does anyone see any problems doing this, other than needing to slightly tilt the unit to catch the centre of the screen and apply a tad of keystone correction?
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top