AVS Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter · #1 ·
I just aquired a set of 6 Irwin Marquee seats from a theater that was refurbishing their hardware. I want to redo the fabric, repaint and install in my planned theater. When taking the bottom seat apart, every one had a small rubber peice loose rattling around. It is a solid cylinder shaped peice about 2 in long and 1/2 wide and is slit halve way thru. It appears to be a bumper of some type but for the live of me I cannot see where it would fit.

Anyone with Irwin seats have seen this before? Thanks in advance.
 

·
Registered
Joined
·
283 Posts
Kind of hard to describe, but in my seats that is indeed a bumper for the seat bottom. It pulls through a hole in the rear side of the seat mounting flange.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top