Greetings - My sub, an Epos Els Sub, has a dial for high pass and low pass filters on the back. The dials are not numbered, just "low" to "max". How should these be set during Audyssey Calibration? Currently both, along with volume, are at 12 oclock.
low pass/high pass filter setup
1 - 3 of 3 Posts
Joined
·
30,800 Posts
1. High pass should be irrelevant since it should only affect the output to other attached speakers.
2. Low pass should be set as high as possible unless it can be bypassed entirely.
3. Volume should be set at the middle point until you see the results of Audyssey.
4. See the "Official Audyssey" thread where there is a guide to what you need to do.
2. Low pass should be set as high as possible unless it can be bypassed entirely.
3. Volume should be set at the middle point until you see the results of Audyssey.
4. See the "Official Audyssey" thread where there is a guide to what you need to do.
1 - 3 of 3 Posts
Join the discussion
