AVS Forum banner
1 - 1 of 1 Posts

· Registered
961 Posts
Discussion Starter · #1 ·
I need to run low voltage PELV wire from my Lutron Grafik Eye to my XanTech IR Blaster (40ft run).

I am making sure that my High Voltage Electrical Wire (14/2) is not near my video and speaker cables,
but should I also do the same for Low Voltage PELV wire, which I need to run from my Lutron Grafik Eye QS to my XanTech IR Blaster?

Will the voltage on a low voltage PELV Electrical Wire be so low that there is no significant interference with speaker or video cable or should I try to run it far away like my High Voltage 14/2 wire?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.