AVS Forum banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
3,496 Posts
Discussion Starter #1
I see at the bottom of the table on Page E-59


"Contact your local dealer for a full list of PC Control Codes if needed."


Does anyone have access to a list of these codes? While the ones listed are interesting, I wonder what else it can do. Hey, I already am using a HTPC for scalling, why not control it as well? Anyone know of someone who has already done it. I could do it, but why re-invent the wheel.



[This message has been edited by jkaiser (edited 10-05-2001).]
 

·
Registered
Joined
·
10 Posts
Federico,


I am also interested in getting the LT150 control codes.


I sent via PM my e-mail address.


Thanks in advance.


jing106
 

·
Registered
Joined
·
10 Posts
thanks for reposting the earlier thread on this subject.


The link to the NEC_serial.pdf is now working. I remember that this link did not work when I tried it out a few weeks ago.

NEC_Serial
 

·
Registered
Joined
·
855 Posts
As for someone else having already built software to send these codes, I use Girder , the Serial Plugin and the LT150 device stuff from the Girder site.


------------------


Huck
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top