[Richard Benson]

several months ago my kids put a hole in the forward driver of my MX-90 sub.(pushed the corner of the grill through the driver). untill then it had worked well. With M&K out of buisness I was looking for help locating a possible replacement driver. It had dual 12" drivers 125watt amp. am not shure but belive it is 8 ohms. The label on the driver is marked MK MX-90-16X2R 12999. I have seen on ebay a 12" M&K driver model # 17035 rated 8ohms but not shure if it would work. Again concerned about the ohm rating. but doubt the mx-90 had 4 ohm drivers.

Also any thoughts about repairing the driver .

 

[sbuck]

I have same problem with my MX90. Did you find a solution? If so please share?


I pulled the driver out...its 16 Ohm & I see 8 Ohm on ebay but I cannot find details on whether the M&K amp can handle lower impedance.


thanks for any info.

 

[strongdog]

 http://www.mksoundsystem.com/

 

[wwinkler]

Places like Parts Express do speaker re-coning.

http://www.parts-express.com/speaker-building.cfm


You might also ask about places that specialize in speaker re-coning. It is a more straightforward solution for you.