Hi,
After a year and a half trouble free operation my 8110 did not start up.
When I switch it on the HFAIL led comes on, BUT it goes off in about a sec. I hear the relays switching but there is no picture and no error led is on after the HFAIL goes off.
I've tried to reseat the board, the daughter board, checked the solder connections, LVPS etc, but still the same.
If I disconnect one deflection yoke connector, and switch on the projector the HFAIL light stays on as it should. Tried a supposedly good 8000 HDM, but got the same 1 sec ON then blank HFAIL and no picture.
Anybody could help? Any idea?
Thanks,
Frank
After a year and a half trouble free operation my 8110 did not start up.
When I switch it on the HFAIL led comes on, BUT it goes off in about a sec. I hear the relays switching but there is no picture and no error led is on after the HFAIL goes off.
I've tried to reseat the board, the daughter board, checked the solder connections, LVPS etc, but still the same.
If I disconnect one deflection yoke connector, and switch on the projector the HFAIL light stays on as it should. Tried a supposedly good 8000 HDM, but got the same 1 sec ON then blank HFAIL and no picture.
Anybody could help? Any idea?
Thanks,
Frank