AVS Forum banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
620 Posts
Discussion Starter · #1 ·
Would be nice if the OSD from my NAD T762 could work on the Ehome S-Video in (channel5). The PJ will not sync on the signal...any good suggestions?


My htpc is setup with 2 desktop settings, one for PAL and one for NTSC.


NTSC: [email protected]

PAL: [email protected]


Powerstrip is changing this by pressing a defined key on an ATI remote...


Would be nice if the PJ could auto-detect settings from powerstrip, and then change recall-mem... :confused:
 

·
Registered
Joined
·
4,801 Posts
Say Rolf


Try another S cable, or maybe you have a bad decoder board in your Marquee.
 

·
Premium Member
Joined
·
17,233 Posts
I bought a 25' s-video cable on ebay

like

6714973536 5725954322 6715390367 (25')

5725938797 (50')

5725938808 (100')


There's a thread a few months ago where we talked about adapters to split the s-video into 2 separate heavy cables with BNC connectors for longer lengths.


Your OSD might be a special case, but for the s-video from my son's PS2, it works much better to use a cheap convertor to scale the svideo up to 800x600 or 1024x768 RGBHV.
 

·
Registered
Joined
·
620 Posts
Discussion Starter · #5 ·
Attached my DVD player with an good quality Monster S-Video cable (1,5m).

Still got "No H-sync" when selecting channel5...


Mybe the input card is defect:(
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top