[luca1031]

Hi to everyone,


I have done some searching but can't seem to find an answer to this my question/problem


I finally set up a Marquee 8500 and it works perfectly ( great picture

)

There is one only problem.

The phase function is not working, both vertical and horizontal.

The picture doesn't move

Can anyone help me to resolve this problem. ?

What board do I check ?

What can I do or replace in order to make it working


The picture is very very cinema like, and for the ceiling mount installation a little phase vertical movement is peraphs necessary


Many thanks


Luca

 

[RolfHult]

Try swapping out boards in the PJ, and you could also clean the connectors and then reinsert them. Also try reset everything in the service-menu.

 

[luca1031]

Thanks RolfHult


I'll try it



Other suggestions ?



Luca

 

[draganm]

I can't help you repair the phaze problem but if you using a proper celing mount bracket it should allow for about 20 degress tilt adjustment. I don't use phaze at all. Leave both at about 50 aand use the HTPC display properties page to move the image around. Good luck