AVS Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
392 Posts
Discussion Starter · #1 ·
I finally got a blue-ray and a hdfury2 and retired my old lumagen scaler.


Problem is the projector won't save the source settings. I make all the adjustments and once I remove and reintroduce the source ASR brings up the correct recall but all the settings, size, bow, pin, sync, convergence, evrything reverts back to the previously saved settings that were setup for the old scaler.


This is making me nuts, anyone have any ideas?


Thanks

Jay
 

·
Registered
Joined
·
4,815 Posts
turn ASR off, it's unmanageable. Simply set up however many channels you need under the channel list and switch between them for multiple sources or resolutions.
 

·
Registered
Joined
·
4,801 Posts
Hello


Press UTIL, 1 and check 3, make sure you are not adjusting a locked memory.



.
 

·
Registered
Joined
·
13 Posts

Quote:
Originally Posted by Avax /forum/post/15519753


Problem is the projector won't save the source settings. I make all the adjustments and once I remove and reintroduce the source ASR brings up the correct recall but all the settings, size, bow, pin, sync, convergence, evrything reverts back to the previously saved settings that were setup for the old scaler.


This is making me nuts, anyone have any ideas?

Bad battery?
 

·
Registered
Joined
·
893 Posts

Quote:
Originally Posted by Tim in Phoenix /forum/post/15519914


Hello


Press UTIL, 1 and check 3, make sure you are not adjusting a locked memory.



.

That's what I was thinking too.


craigr
 

·
Premium Member
Joined
·
1,816 Posts

Quote:
Originally Posted by draganm /forum/post/15519766


turn ASR off, it's unmanageable. Simply set up however many channels you need under the channel list and switch between them for multiple sources or resolutions.

unmanageable? works perfectly for me
 
1 - 7 of 7 Posts
Top