AVS Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
4,815 Posts
Discussion Starter · #1 ·
I really have just a quick question and couldn't find the answer with a search. If a person was to swap tubes between 2 working marquees could the coil magnets be left in place and just unpluged from the circuit boards?(thereby eliminating the need to remove and re-align them with exposure to the high-voltages). I have read that on the sony 1XXX the leads are soldered to the boards and cutting and re-splicing is a no-no, are the Marquees the same way? thanks to everyone......
 

·
Registered
Joined
·
4,801 Posts
Sir


You would be okay with that unless trying to load M8000 or M8110 tubes into an M8500, which uses different focus and flare magnet yokes.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top