AVS Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
620 Posts
Discussion Starter · #1 ·
On my Eh8500 the image are bending down on the bottom left corner. The bending starts at the center, and increasing to the left. It is not possible to adjust this by the setup.

This also happens on 2 others 8500 that was purchased at the same time from an company here in Norway, and they are all identical.


What can cause this?
 

·
Registered
Joined
·
4,801 Posts
Say Rolf


That is very common and easily fixed. Try fixing it in Green Convergence, push CONV, 5, 0901, Random; the Enter button toggles you from moving the zone of adjustment box with the arrow keys to adjusting the zone with the arrow keys.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top