AVS Forum banner
1 - 6 of 6 Posts

·
Banned
Joined
·
7,964 Posts
Discussion Starter · #1 ·
Odd issue I just noticed.


When I try to select channel 077, I get channel 7. When I select 076 I get channel 76. If I use the channel up, it sends the codes and Windows thinks it send 077 but the cable box only receives 07...thereby going to channel 7.


I have changed the channel change speed to 100 (slow), did not make a difference. I also turned off debounce, no luck (in the hidIr registry location).


Any tips from you guys? I hate to have to relearn my cable box. It is a little Motorola Digital Adapter.
 

·
Banned
Joined
·
7,964 Posts
Discussion Starter · #3 ·

Quote:
Originally Posted by kegobeer /forum/post/18232201


What remote and IR sensor are you using? You don't by chance use iMON, do you?

No, I use the Microsoft Remote, Sensor, and Eye Buds.


WIndows shows it receives all three digits but the cable box does not show receiving it.


I hate to have to redo the tuners in Media Center due to having so much manual work involved in getting the HDHomeRun channels combined with the cable box channels.
 

·
Registered
Joined
·
20 Posts
Same here. Sometimes 229 results in channel 29. This occurred even with the low speed setting. I have manually set the keyinterval speed to 500mS. It has only been a few days, but so far so good.


This is with the MS blaster, and DirecTV H20.


Regards, Kris
 

·
Banned
Joined
·
7,964 Posts
Discussion Starter · #6 ·
I redid the tuner setup and it looks good, though there is really only one double digit channel my wife and I watch (FoodTV).


I will keep the 500ms key interval in mind.
 
1 - 6 of 6 Posts
Top