Well its been a long time since I have been on here. Years as a matter of fact.
I have a Mits 55805 calibrated out. Just recently the convergence (or possibly and or the lens has gone out of focus).
So I kind of recall some info way back that the convergence board solders come loose or heat sinks go bad, just cannot recall the info.
And I remember when the set was calibrated out, there is a way to access the lens to adjust.
SO, my 2 questions are, where do I look for the convergence board and how and what do I remove, and in what order, to get to the lens to adjust?
Thanks,
Paul
I have a Mits 55805 calibrated out. Just recently the convergence (or possibly and or the lens has gone out of focus).
So I kind of recall some info way back that the convergence board solders come loose or heat sinks go bad, just cannot recall the info.
And I remember when the set was calibrated out, there is a way to access the lens to adjust.
SO, my 2 questions are, where do I look for the convergence board and how and what do I remove, and in what order, to get to the lens to adjust?
Thanks,
Paul
