AVS Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
4,866 Posts
Discussion Starter · #1 ·
I know most people would just build 2 (or 3 or 10) of the same sub but I am buying one that is already made and am not sure if I will get to build a second.

If I get in a pinch can horns with similar designs and similar low corner be mixed?
 

·
Banned
Joined
·
15,491 Posts
If I get in a pinch can horns with similar designs and similar low corner be mixed?
Different horns will have widely varying phase response, making integrating them difficult.
 

·
Registered
Joined
·
4,866 Posts
Discussion Starter · #5 ·
Different horns will have widely varying phase response, making integrating them difficult.
Thanks Bill

That clarifies why I had heard it was a bad practice.

Thanks again for the many questions you are patient enough to deal with.

Have you ever looked at the DIYAudio collective lab 12/epic 12 Tapped horn (15ish x 30is x 60is, 18hz or so low corner)?

that is what I am buying but am nervous the epic 12's are dried up.

How about using the same horn but different drivers? Is that any better then a true mix of horns?
 

·
Banned
Joined
·
15,491 Posts
How about using the same horn but different drivers? Is that any better then a true mix of horns?
Different drivers won't have much effect, so long as the specs are comparable.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top